Yesterday I installed build 2320 (using upgrade). Now whenever I start MediaCoder, I get an ERROR on STARTUP message. If I "continue", seems to run fine. Details listed below. Any idea why??
===========================================================================
ERROR ON STARTUP:
"Windows - No Disk"
"There is no disk inthe drive. Please insert disk into drive".
CANCEL / TRY AGAIN / CONTINUE
===========================================================================
Media Coder Setup Wizard runs again, and again...
-----------------------------------------------------------
SOFTWARE: Windows XP SP2
MemCoder Version 0.5.0 build 2320 (built on Sun Jul23 11:59:26 2006)
Based on MediaCoder Core build 755 (built on Sun Jul23 11:59:04 2006)
Error On Startup - "Windows - No Disk"
- adlermike1
- Amateur
- Posts: 33
- Joined: Sun Jul 23, 2006 11:28 pm
- Location: USA
Error On Startup - "Windows - No Disk"
Last edited by adlermike1 on Thu Jul 27, 2006 1:05 pm, edited 1 time in total.
I'm not sure why there is such a message on your system. A workaround for this:
1. open mccore.xml with your text editor
2. find for "showsetup"
3. change the line to:
1. open mccore.xml with your text editor
2. find for "showsetup"
3. change the line to:
Code: Select all
<node key="showsetup" type="int" text="Don't show setup for the build" value="755"/>
- adlermike1
- Amateur
- Posts: 33
- Joined: Sun Jul 23, 2006 11:28 pm
- Location: USA
Thanks Stanley. I tried the change you listed, but error still occurs. Original
file had the following line:
<node key="showsetup" type="int" text="Don't show setup for the build"/>
replaced that with:
<node key="showsetup" type="int" text="Don't show setup for the build" value="755"/>
After change, still get:
ERROR ON STARTUP:
"Windows - No Disk"
"There is no disk inthe drive. Please insert disk into drive".
CANCEL / TRY AGAIN / CONTINUE
Cancel or Continue allow program to run ok...
FYI: Did a full re-install just to see if it help, but no luck. Error still occurs on startup..
file had the following line:
<node key="showsetup" type="int" text="Don't show setup for the build"/>
replaced that with:
<node key="showsetup" type="int" text="Don't show setup for the build" value="755"/>
After change, still get:
ERROR ON STARTUP:
"Windows - No Disk"
"There is no disk inthe drive. Please insert disk into drive".
CANCEL / TRY AGAIN / CONTINUE
Cancel or Continue allow program to run ok...
FYI: Did a full re-install just to see if it help, but no luck. Error still occurs on startup..