Search found 7 matches
- Wed Jul 12, 2006 3:21 pm
- Forum: Generic Discussions
- Topic: Deinterlace is not working
- Replies: 17
- Views: 19247
command line
With deinterlace enabled: ".\mplayer\mencoder.exe" "$(SourceFile)" -af volnorm=2 -vf pp=ha:cva:cal:c/lb,harddup -passlogfile "$(TempDir)mcpass2652.log" -ovc x264 -x264encopts qcomp=0.60:dct_decimate:bframes=3:keyint=250:keyint_min=25:frameref=1:qp_min=10:qp_max=51:qp_step=2:qp_constant=26:cabac:dire...
- Tue Jul 11, 2006 4:17 pm
- Forum: Generic Discussions
- Topic: Deinterlace is not working
- Replies: 17
- Views: 19247
I agree
I just did a test conversion from VOB/MPEG2 to H.264 with deinterlace enabled and it did not deinterlace. This used to work in older version. I suspect a bug has crept in. My conclusion is based on visual inspection rather than analyzing the movie but I'm pretty good at spotting interlacing. In fact...
- Sun Jun 25, 2006 9:34 am
- Forum: Generic Discussions
- Topic: Problem compressing DV files over 2GB
- Replies: 3
- Views: 6468
Known issue
As far as I know, it's a known issue. You'll have to work around it by splitting the files to smaller than 2G chunks.
- Sun Jun 18, 2006 4:18 am
- Forum: Development
- Topic: Set Processor Affinity
- Replies: 1
- Views: 7181
Set Processor Affinity
If multithreading is out of the question for the near future (which it probably is), could you set the processor affinity for the single threaded subprocesses? That should cut down on the thrashing and might make things go a bit faster.
- Sun Jun 18, 2006 3:01 am
- Forum: Generic Discussions
- Topic: Video useable on windows XP and 2000 without any install
- Replies: 2
- Views: 4833
Try MS-MPEG4-V2
I've found MS-MPEG4-V2 gives acceptable results, encodes quickly, and works on WMPlayer 10 out of the box. It's fast enough that I often use 2 or 3 pass to get the extra quality boost and accurate bit rate. This codec also plays OK in VLC, though not in quicktime. I typically encode at a video rate ...
- Sat Jun 17, 2006 11:41 am
- Forum: Development
- Topic: Let "Remove" work during encoding.
- Replies: 1
- Views: 7336
Let "Remove" work during encoding.
I often run batch encodings and figure out that one of my pending tasks is broken. However, the "Remove" button doesn't work during encodings even for files that aren't being encoded at that time.
- Sat Jun 17, 2006 11:39 am
- Forum: Development
- Topic: Multithreading support?
- Replies: 3
- Views: 7590