After I convert .rm to .mpeg, the movie frame is too narrow and skinny.
It there anyway to adjust the output frame size before the conversion?
Thanks
The movie frame is narrow and skinny after the conversion
Moderator: HuggiL
-
adlermike1
- Amateur
- Posts: 33
- Joined: Sun Jul 23, 2006 11:28 pm
- Location: USA
might want to review some of the discussion in the following thread.
http://mediacoder.sourceforge.net/forum ... highlight=
Basically, you should be able to choose the "Picture" Tab in lower left, then check the "Resize" box, and then choose the Width x Height from the picklist (dropdown arrow) that will give you the aspect ratio you wanted.
For 16:9, you could use something like 720x400. For 4:3 you could use 640x480.
Unfortunately, you seem to be limited to only these picklist choices, and it seems like MediaCoder does not auto-detect correct aspect ratio. Anyway, try the "resize" setting and it should work for you.
Hope that helps.
http://mediacoder.sourceforge.net/forum ... highlight=
Basically, you should be able to choose the "Picture" Tab in lower left, then check the "Resize" box, and then choose the Width x Height from the picklist (dropdown arrow) that will give you the aspect ratio you wanted.
For 16:9, you could use something like 720x400. For 4:3 you could use 640x480.
Unfortunately, you seem to be limited to only these picklist choices, and it seems like MediaCoder does not auto-detect correct aspect ratio. Anyway, try the "resize" setting and it should work for you.
Hope that helps.