Page 1 of 1

No output file after transcoding

Posted: Sat Apr 27, 2019 8:21 am
by Yatsura
Just installed MediaCoder x64 v0.8.57.5970 and transcoded a WMV3 file into x265.

State is "Done", but in the <Original Folder> (as set Output Folder) is only the original file.

Re: No output file after transcoding

Posted: Sat Apr 27, 2019 9:34 pm
by Yatsura
I solved the issue now. It was about special letters or characters in the file name. Mediacoder cant handle them somehow. There wasnt even an error message or anything. After I renamed the file with standard casual letters only, it worked out fine.